Filter
Top Products
33
PRV-LX1
En
Selecting Recording Destination
The currently selected recording destination (also the
playback source) will be displayed on the front
panel’s central indicator (DVD1, DVD2, HDD
indicator). The [Drive] command on the Function
Menu’s STATUS section also indicates the currently
selected recording destination/playback source. Use
the front panel’s DRIVE SELECT button, or the
[Drive] command in the Function Menu’s STATUS
section to select the recording destination. However,
note that the DRIVE SELECT button is disabled
during display of the Function Menu.
When “HDD” is selected, recording is performed to
the HDD only. If only one DVD-R/RW drive is installed,
“DVD1” is selected; if two drives are present, the
recording destination can be “DVD1” only, “DVD2”
only or both drives “DVD1&2”.
STATUS section = [Drive]
STATUS section = [Drive]
(with expansion DVD drive)
When “DVD & HDD” are selected with the
Function Menu’s EDIT section = [Project] =
[Record/Name] = [Record To] command, recording
is performed to both hard disk drive and DVD
simultaneously, and the recording remains stored on
the hard disk even after the DVD is finalized and
removed from the drive.
EDIT section = [Project] = [Record/Name]
= [Record To]
When recording to hard disk drive, this recorder
performs internal management of recorded data
(clips) in units called “projects.” Multiple clips (up to
a maximum of 255) can be recorded in a single
project, and so long as a project is not changed, clips
can be recorded continuously within a single project.
When you wish to classify your recorded data in
multiple groups, change the project by using the
[Project] command on the STATUS section, and
continue recording.
STATUS section = [Project]
Recording