Filter
Top Products
38
PRV-LX1
En
Recording
APP section = [Auto Capture] = [EDL Command]
= [Command]
Use the APP section = [Auto Capture] = [EDL]
command to perform editing of recording items on
the edit list (deleting, changing order of steps).
APP section = [Auto Capture] = [EDL]
In particular, the contents set with the APP section
= [Auto Capture] = [Chapter Point] command
must be recorded as the next step after setting and
recording the IN/OUT points where you wish to
insert chapter marks.
If chapter points are set and recorded after earlier
setting and recording multiple IN/OUT points, the
chapter points will be added as an additional record
at the end of the edit list, and thus must be changed
to their proper order.
Note:
When recording the edit list, the final IN/OUT point
setting must be as follows: APP section = [Auto
Capture] = [IN/OUT Point] = [Record As]
command must be set to “Title(Stop)”.
Settings for Automatic Recording
When using an external VTR with automatic
recording, the Function Menu’s SET UP section =
[Operation] = [Control Settings] command allows
independent settings to be made for the command
line and time-code acquisition for controlling the
external VTR. To perform automatic recording, set
the SET UP section = [Operation] = [Control
Settings] = [Control] command to “Local”.
The SET UP section = [Operation] = [Control
Settings] = [Port] command allows setting of the
command line to “RS-422A” (or “IEEE1394”).
Use the SET UP section = [Operation] = [Control
Settings] = [Time Code] command to set the time
code line to either “RS-422A” or “LTC” (or
“IEEE1394”). When “DV” is selected as input, the
“IEEE1394” interface is added to the possible
selections.
SET UP section = [Operation] = [Control Settings]
Note:
The external VTR units compliant with the IEEE1394
standards supported by this unit are expected to be
professional VTR components. Ordinary home-use
VTRs which do not support IEEE1394 search
commands cannot be used for automatic recording.
Editing the Edit List
The contents that can be recorded on the edit list
with this recorder are as follows:
The contents set with the APP section = [Auto
Capture] = [IN/OUT Point] and [Chapter Point]
commands are added to the edit list by pressing the
Add to EDL button.
Also, the APP section = [Auto Capture] = [EDL
Command] command can be used to add disc
finalize and initialize commands and wait functions to
the edit list as well. The wait function can be used to
place EDL recording in REC pause mode when
necessary, for example, to change the recording
source’s VTR tape during EDL recording.