Filter
Top Products
92
Using Play List: Audio Split Editing
Use the following procedure to newly register an event
containing an audio split.
◆ NOTE:
•Refer to the “Adding and Registering Audio Split Point (Changing
Registered Point)” section to add an audio split to a registered
event.
•First set the insert mode to INSERT.
1 Open the play list screen.
2 Use the cursor buttons to choose the location where
you want to add the event.
3 Press the INSERT button.
This activates the event register mode.
4 Register an IN point.
Use the operation buttons or search dial to look for a
location to start an event. Then hold down the IN button
and press the ENTRY button.
5 Register the audio split point.
Use the operation buttons or search dial to look for a
location for an audio SPLIT point. Then hold down the
SPLIT button and press the ENTRY button.
6 Register an OUT point
Use the operation buttons or search dial to look for a
location to end an event. Then hold down the OUT button
and press the ENTRY button.
7 Press the EVENT button to end registration.
The INSERT button will also terminate registration.
◆ NOTE:
•In the split display, “–” indicates forward while “+” indicates
reverse direction.
•A split can be registered from the start of the original clip to the
event OUT point.
• Set the IN point before the split point.
•A SPLIT where the audio precedes the video cannot be made
for an event whose IN point is at the start of the clip.
•When using the INSERT button to register a new event or using
the EVENT button in a final event to register an event, register a
SPLIT point before registering an OUT point as a new event will
otherwise be registered.
Registering From Video
4,5,665342
1
7
IN OUT
Clip A
Play list
Event 02Event 01
Video
Audio
Possible audio split range