Panasonic AJ-HPM110P Portable Multimedia Player User Manual


 
Using USB Connectors and SD/SDHC Memory Cards: External Remote Control
113
Using USB Connectors and SD/SDHC Memory Cards
External Remote Control
Use the RS-422A or IEEE1394 interface to send commands to
an external device to control it.
The following functions permit remote control.
PLAY, STOP, STILL, FF, REW, SHTL, JOG
Counter and status LED indication
1 Perform either of the following steps when the
THUMBNAIL and PLAY LIST buttons are off.
•In the RS-422 interface, press the EVENT button.
•In the IEEE1394 interface, hold down the SHIFT button
and press the EVENT button.
This allows the unit to perform remote control of external
devices.
NOTE:
•Select 59.94, 50, 23.98, 24, 29.97 or 25 in setup menu No. 25
SYSTEM FREQ when using RS-422A.
• Select 59.94 or 50 in setup menu No. 25 SYSTEM FREQ when using
IEEE1394.
•In AVC-Intra50
*1
and AVC-Intra100
*1
formats, IEEE1394 input and
output are not available.
• Complete any settings required for controlling a remotely connected
device before pressing the EVENT button.
*1 Available when the optional AVC-Intra Codec board AJ-YBX200G
is installed
In external control mode, the EVENT lamp goes on and the
unit provides the following indications.
The LED goes on to indicate external device status.
Indicates the external device counter
The unit is forcibly set to EE to enable reception of audio
and video from the external device
Counter, status and P mark indications for the external
device are superimposed on the screen.
NOTE:
When 1394 input is selected and the unit is in STILL mode, it goes into
EE mode after engaging STOP mode.
The control buttons listed below enable remote control of an
external device.
*1 Available only when using RS-422A
Remote operation of external devices
Setup Procedure
1
Indications during control of external
devices
Remote operation procedure
STOP Sends the STOP command.
PLAY Sends the PLAY command.
STILL Sends the STILL +0.0 command
REW Sends the REW command.
FF Sends the FF command.
Dial Sends the SHTL or JOG command.
COUNTER
*1
Sends the switch COUNTER command
(CTL/TC only).
RESET
*1
Sends the 0 reset command in CTL mode.