Filter
Top Products
16
Introduction: Features
■ Dial Jog/Dial Shuttle
The jog provides slow playback
*1
at rates between -1.0 to
+1.0.
The shuttle allows high-speed forward and reverse playback
up to 100 times normal speed. At speeds up to 10x, the sound
is also audible.
*1 When 59.94, 50, 29.97, 25 or 60-25 is selected in setup menu No.
25 SYSTEM FREQ.
■ Thumbnails for Managing Clips Visually
The 9-inch color LCD monitor on the front panel displays clips
(thumbnails) that represent P2 card content. Settings can be
made to show only specific clips in the thumbnail screen.
Clips selected from the thumbnail list can be played back
immediately, shot marks can be added, file data regarding the
clips can be confirmed and added and other clip
management operations are also available.
<About clips>
A clip is a single data item that contains video, audio,
metadata and other additional information. Normally, a clip is
one shot generated from the start of recording until recording
stops. However, when a shot spans multiple P2 cards, the
video on each card is handled as an independent clip. The
image at the start of recording appears in the thumbnail
screen as a representative image of that clip.
■ Control of external devices
The RS-422A and IEEE1394 interfaces enable control of a
connected device. RS-422A enables automatic capture of
audio and video by specifying IN/OUT on an external device.
■ Creating Play Lists and the Playback Function
You can select video and audio recorded on the P2 cards
installed in the unit for playback in the desired order.
●A wealth of play list editing functions
• Audio IN point split: The play list makes it possible to move
the audio IN point forward or backward relative to the video
IN point.
• Voice-over: Separately recorded audio data can replace an
audio segment on one or two channels during playback.
• AV overwrite editing: This feature allows you to overwrite
edit and play back any audio and video segment (for 2
channels) on the play list.
■ Time code/Player function for editing provided
This unit has a built-in TCG (time code generator) and TCR
(time code reader). In addition to the internal time code,
external time code input or a VITC input signal can be
recorded as the time code.
The unit can also be used as a player for an editing system
using RS-422A.
■ Support for 59.94 Hz, 50 Hz, 23.98 Hz, 24 Hz and
25 Hz HD/SD
This unit can record and play back 59.94 Hz, 50 Hz, 23.98 Hz,
24 Hz and 25 Hz HD and SD video.
It can also handle analog video, SDI as well as IEEE1394 input
and output.
■ High-quality 8-channel digital audio
8-channel PCM audio where each channel (HD SDI has 8
independent channels while the analog interface has 4
independent channels) can be recorded separately or mixed.
■ Built-in up and down cross conversion
Built-in up and down cross conversion playback function is
provided as standard.
■ Menu-based Setup
Perform setup while viewing the setup menus on the 9-inch
color LCD monitor of this unit or a monitor TV display.
■ Hard Disk connection permits saving card data
to disk
Card data can be saved onto a hard disk that is equipped with
a USB 2.0 interface. Data stored on HDD can be written back
to a card. A USB 2.0 connection with a PC allows you to use
P2 cards inserted in the slots on this unit as mass storage.
This setup provides direct nonlinear editing.
■ AVC-Intra Codec Option Supported
The addition of an optional AVC-Intra Codec board AJ-
YBX200G will enable use of the AVC-Intra Codec.