Filter
Top Products
82
Using Play List: Editing Play Lists
◆ NOTE:
•Pressing the following buttons will also finalize a change.
- Pressing the cursor buttons.
- Pressing the SET button.
•Performing any of the following operations will discard the
changes and make you return to the play list screen.
- Pressing the EXIT button.
- Holding down the SHIFT button and pressing the EXIT button.
- Pressing the PLAY LIST button.
•You cannot make changes that go beyond the start and end
points of a clip.
•You cannot make changes that reverse the IN and OUT point
locations.
•An event with an EXTRA track cannot be modified. Delete the
EXTRA track before modifying the event.
•The IN, OUT and SPLIT buttons allow you to use the TRIM+/–
button for trimming in the event register screen when the time
code is displayed.
You can move and change the order of play list events.
1 Open the play list screen.
2 Select the event you want to move and press the
SET button.
The event is selected and appears in blue. This procedure
can be repeated as necessary to select multiple events.
◆ NOTE:
•To quickly select successive lines
Hold down the SHIFT button and press the SET button (MULTI
SEL) to select all events from the previous time the SET button
was pressed and up to the cursor location where the MULTI SEL
button was pressed.
•To cancel a selection
Place the cursor on a selected event and press the SET button
to cancel the selection.
•To cancel all selections
Hold down the SHIFT button and press the EXIT button
(CANCEL) to cancel all selected lines.
3 Use the cursor buttons to select a destination.
4 Hold down the SHIFT button and press the GO TO
button.
The selected event moves to the location right before the
cursor and the events at the cursor location move
downwards.
◆ NOTE:
•It is not possible to move only the event if that event contains an
EXTRA track. Move the event and the EXTRA track.
Changing Event Order
2,3 4
1