Panasonic AJ-HPM110P Portable Multimedia Player User Manual


 
40
Introduction: Recording From a Variable Frame-Rate Camera
To record active frames from the output of a variable frame-
rate camera, set setup menu No. 040 VFR REC to ON. This
enables instant viewing of slow-motion and fast-motion speed
effects during shooting.
NOTE:
•Audio and external time codes cannot be recorded in this mode.
•In this mode, the remaining P2 card capacity at 60p (50p), the
slowest slow-speed effect, is indicated.
•When 59-23 or 60-24 is set in setup menu No. 25 SYSTEM FREQ,
movement in HD SDI video output may look unnatural when the
input frame rate is something other than 24p.
The unit is capable of AVC-Intra 1080/23.98p native recording
of HD SDI (1080/23.98p over 59.94i) output from an HD camera.
1 Connect the HD SDI (1080/23.98p over 59.94i)
output from an HD camera recorder to the SDI IN
connector and press the INPUT SELECT button to
select SDI.
2 Make the following setup menu settings.
3 Hold down the REC button and the STILL/PAUSE
button simultaneously to set the unit to REC PAUSE
mode.
4 To start recording, press the STILL/PAUSE button
while viewing the video output from the camera HD
SDI output.
NOTE:
•Setup menu No. 155 AUTO REC to TYPE2 and set the CONTROL
switch to REMOTE. The unit will then automatically start and stop
recording as the REC and STOP buttons are pressed on the
camera.
•SDI is output in the 1080/23.98 PsF video format. Analog video and
IEEE1394 are not output.
•The TIME CODE OUT connector does not output a time code and
no time code can be input to the TIME CODE IN connector.
• The SDI output is delayed relative to LCD monitor and monitor video
output. Analog audio, speaker and headphone output is
synchronized to the LCD monitor and monitor video output. To
synchronize these outputs to SDI output, set setup menu No. 778
AUD OUT DLY to ON.
•Set camera TCG to FREE RUN. A TC/UB of an SDI input that cannot
be properly read cannot be normally recorded.
Variable Frame Rate-Recording
Recording HD SDI signals output by an HD camera as 1080/23.98p (requires
optional accessories)
Recording HD SDI signals from camera
output
HD
SDI
(10
80/2
3.98
p over 59.94i) o
utp
ut
SDI IN connecto
r
3 4
1
Item Setting
No.25 SYSTEM FREQ 59-23
No.020 SYS FORMAT 1080p