Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
show traffic control
Description This command displays the current storm traffic control configuration
on the Switch.
Parameters <portlist> - Used to specify port or list of ports for which to display
traffic control settings. The beginning and end of the port list range
are separated by a dash.
Restrictions User Account Command Level – All
Example usage:
To display traffic control setting for ports 1-4:
DES-3028P:4#show traffic control 1-4
Command: show traffic control 1-4
Traffic Storm Control Trap: [None]
Port Thres Broadcast Multicast DLF Action Count Time Shutdown
hold Storm Storm Storm down Interval Forever
------ --------- --------- --------- ----------- -------- ---------- ---------- --------------
1 64 Disabled Disabled Disabled drop 0 5
2 64 Disabled Disabled Disabled drop 0 5
3 64 Disabled Disabled Disabled drop 0 5
4 64 Disabled Disabled Disabled drop 0 5
Total Entries: 4
DES-3028P:4#
config traffic trap
Purpose Used to configure the trap settings for the packet storm control
mechanism.
Syntax
config traffic trap [none | storm_occurred | storm_cleared | both]
Description This command will configure how packet storm control trap messages
will be used when a packet storm is detected by the Switch. This function
can only be used for the software traffic storm control mechanism (when
the action field in the config traffic control command is set as
shutdown).
Parameters none – No notification will be generated or sent when a packet storm
control is detected by the Switch.
storm _occurred – A notification will be generated and sent when a
packet storm has been detected by the Switch.
storm_cleared - A notification will be generated and sent when a packet
storm has been cleared by the Switch.
both - A notification will be generated and sent when a packet storm has
been detected and cleared by the Switch.
Restrictions User Account Command Level – Administrator and Operator
89