Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
21
802.1X COMMANDS
The DES-3028/28P/52/52P implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control.
This mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive frames.
Command Parameters
enable 802.1x
show 802.1x auth_state {ports <portlist>}
show 802.1x auth_configuration {ports <portlist>}
config 802.1x capability ports [<portlist> | all] [authenticator | none]
config 802.1x auth_parameter ports [<portlist> | all] [default | {direction [both | in] | port_control [force_unauth |
auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-
65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> |
max_req <value 1-10> | reauth_period <sec 1-65535> | enable_reauth
[enable | disable]}]
config 802.1x auth_protocol [radius eap | local]
config 802.1x init {port_based ports [<portlist> | all] | mac_based [ports] [<portlist> |all]
{mac_address <macaddr>}]
config 802.1x auth_mode [port_based | mac_based]
config 802.1x reauth {port_based ports [<portlist> | all] | mac_based [ports] [<portlist> | all]
{mac_address <macaddr>}]
config radius add <server_index 1-3> <server_ip> key <passwd 32> [default | {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}]
config radius delete <server_index 1-3>
config radius <server_index 1-3> {ipaddress <server_ip> | key <passwd 32> [auth_port
<udp_port_number 1-65535> acct_port <udp_port_number 1-65535>]}
show radius
create 802.1x guest_vlan <vlan_name 32>
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
delete 802.1x guest_vlan {<vlan_name 32>}
show 802.1x guest_vlan
show auth_statistics {ports <portlist | all>}
show auth_diagnostics {ports <portlist | all>}
show auth_session_statistics {ports <portlist | all>}
show auth_client
show acct_client
create 802.1x user <username 15>
delete 802.1x user <username 15>
show 802.1x user
disable 802.1x
Each command is listed, in detail, in the following sections
133