Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
5
MODIFY BANNER AND PROMPT COMMANDS
Administrator level users can modify the login banner (greeting message) and command prompt by using the commands described
below.
Command Parameters
config command_ prompt [<string 16> | username | default]
config greeting_message {default}
show greeting_message
enable greeting_message
disable greeting_message
The Modify Banner and Prompt commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
config command prompt
Purpose Used to configure the command prompt.
Syntax
config command_prompt [<string 16> | username | default]
Description Administrator level users can use this command to change the
command prompt.
Parameters string 16 - The command prompt can be changed by entering a
new name of no more that 16 characters.
username - The command prompt will be changed to the login
username.
default – The command prompt will reset to factory default
command prompt.
Restrictions Only administrator-level users can issue this command. Other
restrictions include:
• If the “reset/reset config” command is executed, the
modified command prompt will remain modified. However,
the “reset system” command will reset the command
prompt to the original factory banner.
Example usage
To modify the command prompt to “AtYourService”:
DES-3028P:4#config command_prompt AtYourService
Command: config command_prompt AtYourService
Success.
AtYourService:4#
config greeting _message
Purpose Used to configure the login banner (greeting message).
Syntax
config greeting _message {default}
Description Users can use this command to modify the login banner (greeting
)
20