Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
show ipif
Purpose Used to display the configuration of an IP interface on the Switch.
Syntax
show ipif
Description This command will display the configuration of an IP interface on
the Switch.
Parameters None.
Restrictions None.
Example usage:
To display IP interface settings.
DES-3028P:4#show ipif
Command: show ipif
IP Interface Settings
Interface Name : System
IP Address : 10.48.74.122 (MANUAL)
Subnet Mask : 255.0.0.0
VLAN Name : default
Admin. State : Disabled
Link Status : Link UP
Member Ports : 1-28
Total Entries : 1
DES-3028P:4#
enable autoconfig
Purpose Used to activate the autoconfiguration function for the Switch. This
will load a previously saved configuration file for current use.
Syntax
enable autoconfig
Description When autoconfig is enabled on the Switch, the DHCP reply will
contain a configuration file and path name. It will then request the
file from the TFTP server specified in the reply. When autoconfig is
enabled, the ipif settings will automatically become DHCP client.
Parameters None.
Restrictions When autoconfig is enabled, the Switch becomes a DHCP client
automatically (same as: config ipif System dhcp). The DHCP server
must have the TFTP server IP address and configuration file name,
and be configured to deliver this information in the data field of the
DHCP reply packet. The TFTP server must be running and have
the requested configuration file in its base directory when the
request is received from the Switch. Consult the DHCP server and
TFTP server software instructions for information on loading a boot
file or configuration file.
Example usage:
To enable autoconfiguration on the Switch:
119