Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
show 802.1x auth_configuration
Purpose Used to display the current configuration of the 802.1x server on the
Switch.
Syntax
show 802.1x auth_configuration {ports <portlist>}
Description The show 802.1x auth_configuration command is used to display the
802.1x Port-based or MAC-based Network Access control local users
currently configured on the Switch.
Parameters
ports <portlist> − Specifies a port or range of ports to view.
The following details are displayed:
802.1x Enabled / Disabled − Shows the current status of 802.1x
functions on the Switch.
Authentication Mode – Shows the authentication mode, whether it be
by MAC address or by port.
Capability: Authenticator/None − Shows the capability of 802.1x
functions on the port number displayed above. There are two 802.1x
capabilities that can be set on the Switch: Authenticator and None.
ReAuthPeriod − Shows the time interval between successive re-
authentications.
Authentication Protocol: Radius_Eap − Shows the authentication
protocol suite in use between the Switch and a RADIUS server. May
read Radius_Eap or local.
Port number − Shows the physical port number on the Switch.
AdminCtlDir: Both / In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
OpenCtlDir: Both / In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
Port Control: ForceAuth / ForceUnauth / Auto − Shows the
administrative control over the port’s authorization status. ForceAuth
forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure
and the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant
(user) to send EAP Request / Identity packets.
SuppTimeout − Shows the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request / Identity packets.
ServerTimeout − Shows the length of time to wait for a response from a
RADIUS server.
MaxReq − Shows the maximum number of times to retry sending
packets to the supplicant.
ReAuthenticate: Enabled / Disabled − Shows whether or not to re-
authenticate.
None. Restrictions
Example usage:
To display the 802.1x authentication states:
135