Linksys DES-3028/DES-3028P/DES-3052/DES-3052P Portable DVD Player User Manual


 
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
delete authen server_host
Description This command is used to delete a user-defined authentication
server host previously created on the Switch.
Parameters server_host <ipaddr> - The IP address of the remote server host to
be deleted.
protocol – The protocol used by the server host the user wishes to
delete. The user may choose one of the following:
Restrictions Only administrator-level users can issue this command.
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes the
TACACS+ protocol.
radius - Enter this parameter if the server host utilizes the
RADIUS protocol.
Example usage:
To delete a user-defined TACACS+ authentication server host:
DES-3028P:4#delete authen server_host 10.1.1.121 protocol tacacs+
Command: delete authen server_host 10.1.1.121 protocol tacacs+
Success.
DES-3028P:4#
show authen server_host
Purpose Used to view a user-defined authentication server host.
Syntax
show authen server_host
Description This command is used to view user-defined authentication server
hosts previously created on the Switch.
The following parameters are displayed:
IP Address – The IP address of the authentication server host.
Protocol – The protocol used by the server host. Possible results will
include TACACS, XTACACS, TACACS+ or RADIUS.
Port – The virtual port number on the server host. The default value is
49.
Timeout - The time in seconds the Switch will wait for the server host
to reply to an authentication request.
Retransmit - The value in the retransmit field denotes how many
times the device will resend an authentication request when the
TACACS server does not respond. This field is inoperable for the
tacacs+ protocol.
Key - Authentication key to be shared with a configured TACACS+
server only.
Parameters None.
Restrictions None.
Example usage:
To view authentication server hosts currently set on the Switch:
199