Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
16
VLAN COMMANDS
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
create vlan <vlan_name 32> {tag <vlanid 2-4094> | advertisement}
delete vlan <vlan_name 32>
config vlan <vlan_name 32> {[add [tagged | untagged | forbidden] | delete]
<portlist> | advertisement [enable | disable]}
config gvrp [<portlist> | all] {state [enable | disable] | ingress_checking [enable
| disable] | acceptable_frame [tagged_only | admit_all] | pvid
<vlanid 1-4094>}
enable gvrp
disable gvrp
show vlan <vlan_name 32>
show gvrp <portlist>
Each command is listed, in detail, in the following sections.
create vlan
Purpose Used to create a VLAN on the Switch.
Syntax
create vlan <vlan_name 32> {tag <vlanid 2-4094> |
advertisement}
Description This command allows the user to create a VLAN on the Switch.
Parameters
<vlan_name 32> − The name of the VLAN to be created.
<vlanid 2-4094> − The VLAN ID of the VLAN to be created. Allowed
values = 2-4094
advertisement − Specifies that the VLAN is able to join GVRP. If
this parameter is not set, the VLAN cannot be configured to have
forbidden ports.
Restrictions Each VLAN name can be up to 32 characters. If the VLAN is not
given a tag, it will be a port-based VLAN. Up to 4094 static VLANs
may be created per configuration. Only administrator-level users
can issue this command.
Example usage:
To create a VLAN v1, tag 2:
DES-3028P:4#create vlan v1 tag 2
Command: create vlan v1 tag 2
Success.
DES-3028P:4#
108