Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config 802.1x auth_parameter
default parameter will return all ports in the specified range to their
default 802.1x settings.
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
direction [both | in] − Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or
just the receiving direction.
port_control − Configures the administrative control over the
authentication process for the range of ports. The user has the
following authentication options:
quiet_period <sec 0-65535> − Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response
from a supplicant (user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535> - Configure the length of time to wait
for a response from a RADIUS server.
max_req <value 1-10> − Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable] − Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Restrictions Only administrator-level users can issue this command.
Parameters
default − Returns all of the ports in the specified range to their
802.1x default settings.
• force_auth − Forces the Authenticator for the port to
become authorized. Network access is allowed.
• auto
−
Allows the port’s status to reflect the outcome of the
authentication process.
• force_unauth − Forces the Authenticator for the port to
become unauthorized. Network access will be blocked.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DES-3028P:4#config 802.1x auth_parameter ports 1–20 direction both
Command: config 802.1x auth_parameter ports 1–20 direction both
Success.
DES-3028P:4#
config 802.1x auth_protocol
Purpose Used to configure the 802.1x authentication protocol on the Switch.
Syntax
config 802.1x auth_protocol [local | radius_eap]
The config 802.1x auth_protocol command enables users to
configure the authentication protocol.
Description
139