Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
18
BASIC IP COMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ipif [System] [{ipaddress <network_address> | vlan <vlan_name 32>
| state [enable | disable]} | bootp | dhcp]
show ipif
enable autoconfig*
Each command is listed, in detail, in the following sections.
*See Switch Utility Commands for descriptions of all autoconfig commands.
config ipif
Purpose Used to configure the System IP interface.
Syntax
config ipif [System] [{ipaddress <network_address> [vlan
<vlan_name 32> | state [enable | disable]} | bootp | dhcp]
Description This command is used to configure the System IP interface on the
Switch.
Parameters System - Enter System.
ipaddress <network_address> − IP address and netmask of the IP
interface to be created. Users can specify the address and mask
information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<vlan_name 32> − The name of the VLAN corresponding to the
System IP interface.
state [enable | disable] − Allows users to enable or disable the IP
interface.
bootp − Allows the selection of the BOOTP protocol for the
assignment of an IP address to the Switch’s System IP interface.
dhcp − Allows the selection of the DHCP protocol for the assignment
of an IP address to the Switch’s System IP interface. If users are
using the autoconfig feature, the Switch becomes a DHCP client
automatically so it is not necessary to change the ipif settings.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the IP interface System:
DES-3028P:4#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DES-3028P:4#
118