Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
Command Parameters
delete snmp host <ipaddr>
show snmp host <ipaddr>
create trusted_host <ipaddr>
delete trusted_host <ipaddr>
show trusted_host <ipaddr>
enable snmp traps
enable snmp authenticate traps
show snmp traps
disable snmp traps
disable snmp authenticate traps
config snmp system_contact <sw_contact>
config snmp system_location <sw_location>
config snmp system_name <sw_name>
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Used to create a new SNMP user and adds the user to an SNMP group that is also
created by this command.
Syntax create snmp user <SNMP_name 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha <auth_password 8-20>]
priv [none | des <priv_password 8-16>] | by_key auth [md5 <auth_key 32-32> |
sha <auth_key 40-40>] priv [none | des <priv_key 32-32>]]}
Description
The create snmp user command creates a new SNMP user and adds the user to
an SNMP group that is also created by this command. SNMP ensures:
Message integrity − Ensures that packets have not been tampered with during
transit.
Authentication − Determines if an SNMP message is from a valid source.
Encryption − Scrambles the contents of messages to prevent it from being viewed
by an unauthorized source.
Parameters
<SNMP_name 32> − An alphanumeric name of up to 32 characters that will identify
the new SNMP user.
<groupname 32> − An alphanumeric name of up to 32 characters that will identify
the SNMP group the new SNMP user will be associated with.
encrypted – Allows the user to choose a type of authorization for authentication
using SNMP. The user may choose:
•
•
•
by_password – Requires the SNMP user to enter a password for
authentication and privacy. The password is defined by specifying the
auth_password below. This method is recommended.
by_key – Requires the SNMP user to enter a encryption key for
authentication and privacy. The key is defined by specifying the key in hex
form below. This method is not recommended.
auth - The user may also choose the type of authentication algorithms used to
authenticate the snmp user. The choices are:
md5 − Specifies that the HMAC-MD5-96 authentication level will be used.
md5 may be utilized by entering one of the following:
31