Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
7 off 802.1p off
8 off 802.1p off
9 off 802.1p off
10 off 802.1p off
11 off 802.1p off
12 off 802.1p off
13 off 802.1p off
14 off 802.1p off
15 off 802.1p off
16 off 802.1p off
17 off 802.1p off
18 off 802.1p off
19 off 802.1p off
20 off 802.1p off
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
config cos port_mapping
Purpose Used to map a specific port to one of the hardware queues
available on the switch.
Syntax
config cos port_mapping [0-3] port [<portlist> | all]
Description The config cos port_mapping command is used to configure port-to-
class CoS mapping.
Parameters
0-3 − The number of the switch’s hardware priority queue. The
switch has eight hardware priority queues available. They are
numbered between 0 (the lowest priority queue) and 3 (the highest
priority queue).
<portlist> − Specifies a port or range of ports to be configured.
all − To set all ports in the system at once, you may use the “all”
parameter.
Restrictions You must have administrator privileges.
Example usage:
To configure a specific CoS queue to be mapped to a destination port 1:
DES-3028P:4# config cos port_mapping 3 port 1
Command: config cos port_mapping 3 port 1
Success.
DES-3028P:4#
100