Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config dst
Parameters
s_day – Configure the day of the week in which DST begins.
e_day - Configure the day of the week in which DST ends.
s_mth - Configure the month in which DST begins.
e_mth - Configure the month in which DST ends.
s_time – Configure the time of day to begin DST.
e_time - Configure the time of day to end DST.
s_date - Configure the specific date (day of the month) to begin DST.
e_date - Configure the specific date (day of the month) to begin DST.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30,60,90,120. The
default value is 60
Restrictions Only administrator-level users can issue this command.
<end_week 1-4,last> - The number of the week during the month in
which DST ends where 1 is the first week, 2 is the second week
and so on, last is the last week of the month.
•
•
•
•
•
•
<start_day sun-sat> - The day of the week in which DST begins
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat)
<end_day sun-sat> - The day of the week in which DST ends
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat)
<start_mth 1-12> - The month to begin DST expressed as a
number.
<end_mth 1-12> - The month to end DST expressed as a number.
<start_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
<end_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
•
•
•
<start_date 1-31> - The start date is expressed numerically.
<end_date 1-31> - The end date is expressed numerically.
Example usage:
To configure daylight savings time on the Switch:
DES-3028P:4#config dst repeating s_week 2 s_day tue s_mth 4
s_time 15:00 e_week 2 e_day wed e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s_week 2 s_day tue s_mth 4 s_time
15:00 e_week 2 e_day wed e_mth 10 e_time 15:30 offset 30
Success.
DES-3028P:4#
show time
Purpose Used to display the current time settings and status.
Syntax
show time
This will display system time and date configuration as well as
display current system time.
Restrictions None.
Description
Parameters None.
174