Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config greeting _message
message).
Parameters default – If the user enters default to the modify banner command, then
the banner will be reset to the original factory banner.
To open the Banner Editor, click Enter after typing the config
greeting_message command. Type the information to be displayed on
the banner by using the commands described on the Banner Editor:
Quit without save: Ctrl+C
Save and quit: Ctrl+W
Move cursor: Left/Right/Up/Down
Delete line: Ctrl+D
Erase all setting: Ctrl+X
Reload original setting: Ctrl+L
Restrictions Only administrator-level users can issue this command. Other restrictions
include:
• If the “reset/reset config” command is executed, the modified
banner will remain modified. However, the “reset system”
command will reset the modified banner to the original factory
banner.
• The capacity of the banner is 6*80. 6 Lines and 80 characters per
line.
• Ctrl+W will only save the modified banner in the DRAM. Users
need to type the “save” command to save it into FLASH.
• Only valid in threshold level.
Example usage:
To modify the banner to read “Say goodnight, Gracie”:
DES-3028P:4# config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
Say Goodnight, Gracie
DGS-3028P Fast Ethernet Switch
Command Line Interface
Firmware: Build 1.00-B22
Copyright(C) 2006-2009D-Link Corporation. All rights reserved.
================================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
--------------------------------------------------------------------------------------------------------------------------------------------
21