Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config 802.1x auth_protocol
Parameters radius_eap | local – Specify the type of authentication protocol
desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the authentication protocol on the Switch:
DES-3028P:4# config 802.1x auth_protocol radius_eap
Command: config 802.1x auth_protocol radius_eap
Success.
DES-3028P:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
config 802.1x init {port_based ports [<portlist> | all] |
mac_based | ports [<portlist> | all] {mac_address <macaddr>}]
Description The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
Parameters port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can
then be specified.
mac_based − This instructs the Switch to initialize 802.1x functions
based only on the MAC address. MAC addresses approved for
initialization can then be specified.
mac_address <macaddr> - Enter the MAC address to be initialized.
ports <portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
Restrictions
Syntax
Only administrator-level users can issue this command.
Example usage:
To initialize the authentication state machine of all ports:
DES-3028P:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DES-3028P:4#
config 802.1x reauth
Purpose Used to configure the 802.1x re-authentication feature of the Switch.
Syntax
config 802.1x reauth {port_based ports [<portlist> | all] |
mac_based | ports [<portlist> | all] {mac_address <macaddr>}]
Description The config 802.1x reauth command is used to re-authenticate a
previously authenticated device based on port number.
Parameters port_based – This instructs the Switch to re-authorize 802.1x functions
bdl th t bPt df
th i ti
140