Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
config authen server_group
XTACACS protocol may be added to this group.
tacacs+ – Use this parameter to utilize the built-in TACACS+
server protocol on the Switch. Only server hosts utilizing the
TACACS+ protocol may be added to this group.
radius – Use this parameter to utilize the built-in RADIUS server
protocol on the Switch. Only server hosts utilizing the RADIUS
protocol may be added to this group.
<string 15> - Enter an alphanumeric string of up to 15 characters
to define the previously created server group. This group may add
any combination of server hosts to it, regardless of protocol.
add/delete – Enter the correct parameter to add or delete a server host
from a server group.
server_host <ipaddr> - Enter the IP address of the previously configured
server host to add or delete.
protocol – Enter the protocol utilized by the server host. There are three
options:
Restrictions Only administrator-level users can issue this command.
tacacs – Use this parameter to define the protocol if the server
host is using the TACACS authentication protocol.
xtacacs – Use this parameter to define the protocol if the server
host is using the XTACACS authentication protocol.
tacacs+ – Use this parameter to define the protocol if the server
host is using the TACACS+ authentication protocol.
radius – Use this parameter to define the protocol if the server
host is using the RADIUS authentication protocol.
Example usage:
To add an authentication host to server group “group_1”:
DES-3028P:4# config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Command: config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Success.
DES-3028P:4#
delete authen server_group
Used to delete a user-defined authentication server group.
delete authen server_group <string 15>
Description This command will delete an authentication server group.
Parameters <string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be deleted.
Restrictions Only administrator-level users can issue this command.
Purpose
Syntax
Example usage:
To delete the server group “group_1”:
201