Filter
Top Products
DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
create access_profile
<hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> |
offset_48-63 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-
0xffffffff> | offset_64-79 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
0x0-0xffffffff>}] profile_id <value 1-256>
Description The create access_profile command is used to create an access profile on the Switch and to
define which parts of each incoming frame’s header the Switch will examine. Masks can be
entered that will be combined with the values the Switch finds in the specified frame header
fields. Specific values for the rules are entered using the config access_profile command,
below.
Parameters
ethernet − Specifies that the Switch will examine the layer 2 part of each packet header.
ip − Specifies that the Switch will examine the IP address in each frame’s header.
udp − Specifies that the Switch will examine each frame’s Universal Datagram Protocol (UDP)
field.
vlan − Specifies that the Switch will examine the VLAN part of each packet header. •
•
•
•
•
source_mac <macmask> − Specifies a MAC address mask for the source MAC
address. This mask is entered in a hexadecimal format.
destination_mac <macmask> − Specifies a MAC address mask for the destination
MAC address.
802.1p − Specifies that the Switch will examine the 802.1p priority value in the
frame’s header.
ethernet_type − Specifies that the Switch will examine the Ethernet type value in
each frame’s header.
vlan − Specifies a VLAN mask. •
•
•
•
•
•
•
•
•
•
•
source_ip_mask <netmask> − Specifies an IP address mask for the source IP
address.
destination_ip_mask <netmask> − Specifies an IP address mask for the destination
IP address.
dscp − Specifies that the Switch will examine the DiffServ Code Point (DSCP) field in
each frame’s header.
icmp − Specifies that the Switch will examine the Internet Control Message Protocol
(ICMP) field in each frame’s header.
igmp − Specifies that the Switch will examine each frame’s Internet Group
Management Protocol (IGMP) field.
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the destination port.
flag_mask – Enter the appropriate flag_mask parameter. All incoming packets have
TCP port numbers contained in them as the forwarding criterion. These numbers
have flag bits associated with them which are parts of a packet that determine what
to do with the packet. The user may deny packets by denying certain flag bits within
the packets. The user may choose between all, urg (urgent), ack
(acknowledgement), psh (push), rst (reset), syn (synchronize) and fin (finish).
src_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the destination port.
153