Filter
Top Products
78
AUDIO Menu screen
Item Setting Description
AUDIO MODE
A.OUT AT
SEARCH
AUDIO INPUT
SEL
AUDIO OUT
LEV
V.FADE
PAGE BACK
ⅷ 48 K
32 K
OFF
ⅷ ON
XLR
ⅷ RCA
–12 dB
ⅷ –20 dB
OFF
ⅷ ON
For selecting the audio sampling frequency for recording.
48 K : Records at 48 kHz. It records in the 2-channel
stereo mode. No audio dubbing allowed.
32 K : Records at 32 kHz. It records in the 4-channel
mode. To perform audio dubbing on CH3 and CH4
later, use this setting.
Memo
Setting of this item is not required for DV signal input.
For enabling/disabling audio output from this AUDIO OUT termi-
nal during searches.
OFF : Output off.
ON : Output on.
Use this setting when the XLRIN board SA-X61U (sold separately)
is installed. For selecting the audio input terminal.
XLR : Audio input terminal of SA-X61U
RCA : AUDIO INPUT terminal of the unit
For selecting the level for playback audio output.
–12 dB :Select here to reduce the analog sound output
level. It will be reduced by 8 dB.
–20 dB :Usually, this setting is used.
For enabling/disabling the V.Fade function, which reduces sound
noise in playback that is produced at jointed parts of recording.
OFF : V.FADE function disabled.
ON : V.FADE function enabled.
For returning to the TOP MENU screen.
MENU SCREENS
– Description of the Menu screens – (continued)
77
REMOTE menu
ⅷ 0F
|
15F
OFF
ⅷ ON
ⅷ TYPE1
TYPE2
TYPE3
TYPE4
TYPE5
TYPE6
TYPE7
ⅷ OFF
L EDGE
H EDGE
L LEVEL
PB START
DELAY
SYNCHRONI-
ZATION
CONTROLLER
SEL
FOOT SW
PAGE BACK
For adjusting the edit timing. With the remote controller in use, if
the start points of edit are not concurrent, adjust the playback
startup timing:
0F : No correction.
1F to 15F : Delays the timing by the number of frames set by
the user. When BR-DV6000 is connected to an
editing remote controller with no bump function,
use this setting to adjust the editing precision.
For enabling/disabling the bump function when BR-DV6000 is
connected to an editing remote controller:
OFF : No synchronization.
ON : Performs synchronization. The editing precision
is enhanced. Please set the pre-roll time to at least
7 seconds.
For setting the type of controller to be connected when remote
control is enabled with the RS-422A interface:
TYPE1 : RM-G820
TYPE2 : RM-G860 (set the preroll time to at least 10
seconds)
TYPE3 : AG-A850
TYPE4 : RM-450,PVE-500
TYPE5 - TYPE7 : (Not in use)
For setting when an external switch (e.g., a footswitch) is con-
nected to the SERIAL REMOTE terminal. Before operating an
external switch (footswitch) with L EDGE or H EDGE, turn BR-
DV6000 to the RECORDING PAUSE or RECORDING mode:
OFF : For when the external switch is not used.
L EDGE : Recording and recording pause is switched at the
LOW edge of the external switch signal.
H EDGE : Recording and recording pause is switched at the
HIGH edge of the external switch signal.
L LEVEL :Record at the LOW edge and pause recording at
the HIGH edge of the external switch signal.
Return to the REMOTE (1/2) Menu screen.
Items Setting Description
Ⅵ REMOTE (2/2) Menu screen (continued)