Filter
Top Products
Read Status Operating Instructions
MRP-2001 & MRP-2001E PN 53040:A 4/16/2007 93
4.16.1 FACP Configuration
Pressing 1 while viewing Read Status Screen #1 will display the type of configuration programmed
into the FACP (refer to "FACP CONFIG (Application Templates)" on page 50). As an example, if
Template 7 was programmed as the FACP configuration, the following screen will be displayed:
4.16.2 Input Zones
Pressing 2 while viewing Read Status Screen #1 will cause the following screens to be displayed:
Pressing the down arrow key will allow the selection of Zones 4-6.
The operator selects the zone which is to be viewed by pressing the number corresponding to the
desired zone in each screen. For example, if 1 is pressed in the first screen, the display will change
to a screen similar to the following:
Pressing the down arrow key, while viewing the screen shown above, will allow the operator to
view additional programming information about the selected device, such as:
• Enable/Disable Status
• Device Type
• Output Circuit MAP
• Adjective/Noun descriptor
READ FACP CONFIG
TEMPLATE 7
SINGLE HAZARD
X-ZONE MAN REL SW
READ INPUT ZONES
1=ZONE 1
2=ZONE 2
3=ZONE 3
READ INPUT ZONE 1
PULL STATION
PRESS TO VIEW
Normal