2-40
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 2 Shelf Management Commands
commitrev
Note Of special note in Table 2-8, runrev causes the standby card to become the active card and run the
new version of firmware. The reversed location of the “Active” and “Standby” columns shows these
changed states.
Cards on Which This Command Runs
PXM45
Syntax
commitrev <slot> <revision>
Syntax Description
Related Commands
loadrev, abortrev, runrev, setrev, dspversion
Attributes
Example
Commit the PXM45 in slot 8 to the graceful upgrade to file pxm45_002.000.000.000_mgx.fw (so 2.0(0)
is the version). The system prompts you to confirm that you want the command to execute.
pinnacle.8.PXM.a > commitrev 8 2.0(0)
Table 2-8 Redundant Pair Upgrade From 2.x to 2.y
Firmware
status Before upgrade After loadrev After runrev After commitrev
Active Standby Active Standby Standby Active Standby Active
Primary 2.x 2.x 2.x 2.x 2.y 2.y 2.y 2.y
Secondary 2.x 2.x 2.y 2.y 2.x 2.x 2.y 2.y
Current 2.x 2.x 2.x 2.y 2.y 2.y 2.y 2.y
abortrev resets the
standby card.
abortrev resets
both cards.
slot Number of the slot where firmware must revert to previous version.
revision Revision number derived from the name of the firmware file. For an explanation, see
the section, “Version Numbering Conventions,” in the loadrev description.
Log: log State: active Privilege: SERVICE_GP
