5-47
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 5 PNNI Commands
dbgpnni
dbgpnni
Debug PNNI Messages—specify which PNNI debug messages are enabled.
The dbgpnni command lets you specify the types of debug messages that appear in the display of the
dsppnni-dbg command.
Note The selections you make with this command can significantly affect network performance. The
simultaneous dumping of multiple types of debug messages can increase the overhead more than
incrementally as each dump is added. Consider the options individually rather than simultaneously.
Cards on Which This Command Runs
PXM45
Syntax
dbgpnni
[-all {on | off}]
[-hello {on | off}]
[-election {on | off}]
[-nbr {on | off}]
[-itf {on | off}]
[-timer {on | off}]
[-lgn {on | off}]
[-spt {on | off}]
[-nodereachability {on | off}]
[-address {on | off}]
[-itdb {on | off}]
[-ra {on | off}]
[-cp {on | off}]
[-linkselection {on | off}]
Syntax Description
-all Specify whether all types of debug messages go to the console.
on: All types of debug messages go to the console.
off: Only the debug message-types specified on by the other dbgpnni
parameters are active.
Default: none
-timer Specify whether the timer debug messages go to the console.
on: The timer debug messages go to the console.
off: The timer debug messages do not go to the console.
Default: none
-hello Specify whether the hello debug messages go to the console.
on: The hello debug messages go to the console.
off: The hello debug messages do not go to the console.
Default: none
