2-32
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 2 Shelf Management Commands
cnfsnmp
cnfsnmp
Configure SNMP Strings
Configure the SNMP strings. The three strings are community, contact, and system location. You can
configure only one of these strings with a single execution of cnfsnmp.
Cards on Which This Command Executes
PXM45
Syntax
cnfsnmp
-community [string <ro | rw>]
-contact [string]
-location [string]
Syntax Description
Attributes
Related Commands
dspsnmp
-community Keyword that establishes the community access string to permit access to SNMPv1
protocol.
The string acts like a password and permits access to the SNMP Protocol. Further, the
access of either read-only or read-write allows operations on MIB Objects according
to the setting. The setting can be either “ro” for read-only or “rw” for read-write. The
default is read-only With read-only, authorized management stations are only able to
retrieve MIB objects.
With read-write access, authorized management stations are able to retrieve and
modify MIB objects.
-contact Keyword that specifies the system contact string for sysContact MIB object in
MIB-II. The string in this case is text that describes the contact. For example, the
contact could be an administrator’s email address. The default is no text.
-location Keyword that specifies the location of the system. The default is no text. The system
location string is used for sysLocation MIB object in MIB-II.
Log: log State: active Privilege: SUPER_GP
