3-46
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3 Equipment and Resource Provisioning
dnln
dnln
Down Line
The dnln command lets you de-activate a line on the current card. Before you can de-activate a line, you
must take the following steps:
Step 1 Remove connections. Use delcon or delcons.
Step 2 Remove any resource partitions. Use dsprscprtn to see existing partitions and delrscprtn to remove
partitions.
Step 3 Remove all logical ports. Use dspports to see existing logical ports on the line and delport to remove
logical ports.
Cards on Which This Command Runs
AXSM
Syntax
dnln <bay.line>
Syntax Description
Related Commands
dspln, dsplns, cnfln, upln
Attributes
Example
De-activate line 1 in bay 1.
MGX8850.1.AXSM.a > dnln 1.1
bay.line Identifies the bay (1 or 2) and the number of the line. The line number is from 1 to the
highest numbered line on the back card. For the range of line numbers on specific
AXSM models, see Table 3-1.
Log: log State: active Privilege: GROUP1
