6-81
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6 Logical Node, Port, and Signaling Commands
dsppncons
dsppncons
Display Port Connections
Displays a summary of SVCs and SPVCs on one port or all ports. The default is all connections on all
ports because all parameters are optional. You can specify a starting VPI or VCI to begin a range of
connections. In addition, you can display one of two types: point-to-point or point-to-multipoint.
Cards on Which This Command Runs
PXM45
Syntax
dsppncons
[-port
portid]
[-vpi starting-vpi]
[-vci starting-vci]
[-type {p2p | p2mp}]
Syntax Description
Related Commands
dsppncon
Attributes
-port The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page 6-4.
-vpi Starting VPI.
-vci Starting VCI.
-type Causes the system to display only point-to-point or point-to-multipoint. Without this
option, the system displays both types. No default value exists if you include the keyword
type on the command line, you must enter one of the possible entries.
• “p2p” for point-to-point
• “p2mp” for point-to-multipoint
Log: nolog State: active, standby Privilege: ANYUSER
