6-96
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6 Logical Node, Port, and Signaling Commands
dsppnports
Related Commands
dsppnportrsrc, dsppnport
Attributes
Description of the dsppnports Connection Summaries
This section contains the following:
1. A list identifies all fields in the connection summary part of the display.
2. A simple network description illustrates how an SPVC in a three-node network would appear in the
summary part of the display.
3. A description of the summary for a DAX connection follows the SPVC explanation.
The list of summary fields follows:
• Total point-to-point or point-to-multipoint connections
–
SVCC, switched virtual channel connections
–
SVPC, switched virtual path connections
–
SPVCD, semi-permanent virtual channel DAX connections
–
SPVPD, semi-permanent virtual path DAX connections
–
SPVCR, active (routed) semi-permanent virtual circuits
–
SPVPR, active (routed) semi-permanent virtual paths
–
Total of all the preceding types
• Configured SPVC endpoints for either point-to-point and point-to-multipoint connections
–
SPVCD, semi-permanent virtual channel DAX connections
–
SPVPD, semi-permanent virtual path DAX connections
–
SPVCR, active (routed) semi-permanent virtual circuits
–
SPVPR, active (routed) semi-permanent virtual paths
–
Totals for the preceding types
EnableNotUp This port is not accessible due to hardware.
UpAndNormal This port is physically up, and the protocol is enabled.
Log: nolog State: active, standby Privilege: ANYUSER
