9-111
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 9 Troubleshooting Commands
dspln
dspln
Display Line
Display the configuration of a physical line.
Note The connection count includes control VCs when you execute dspln on the CLI of a service module.
However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the display
does not include control VCs.
Cards on Which This Command Runs
AXSM
Syntax
dspln
<-ds3 | -sonet> <bay.line>
Syntax Description
Related Commands
upln, cnfln, delln
Attributes
Examples
Display T3 line 1 on the current AXSM.
pinnacle.2.AXSM.a > dspln -ds3 1.2
LineNum: 1.2
LineEnable: Down
LineType: ds3cbitadm
LineCoding: ds3B3ZS
LineLength(meters): 0
LineOOFCriteria: fBits3Of8
LineAIScBitsCheck: Check
LineLoopback: NoLoop
Xmt. Clock source: localTiming
LineRcvFEACValidation: 4 out of 5 FEAC codes
-ds3 Command delineator that precedes the line number entry for a T3 of E3 line.
-sonet Command delineator that precedes the line number entry for a SONET line.
bay.line Identifies the bay (1 or 2) and the number of the line. The line number can be 1 to the
highest numbered line on the back card.
Log: no log State: active, standby Privilege: ANYUSER
