3-7
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3 Equipment and Resource Provisioning
addapsln
Note APS 1:1 is only supported on Model B software. It is not supported on Model A software.
3
Cards on Which This Command Runs
AXSM
AXSM Syntax
addapsln <workingIndex> <protectIndex> <archmode>
AXSM Syntax Description
Related Commands
cnfapsln, delapsln, dspapsln, dspapslns, switchapsln, dspapsbkplane, clrbecnt, dspbecnt
Attributes
Example
The following example assigns 1+1 APS redundancy to two lines on the same card:
MGX8850.9.AXSM.a > addapsln 9.2.1 9.2.2 1
workingIndex Slot number, bay number, and line number of the working line in the format:
slot.bay.line
protectIndex Slot number, bay number, and line number of the protection line in the format:
slot.bay.line
archmode The APS architecture mode to be used on the working/protection line pairs.
• 1 = 1+1 – provides line redundancy with traffic on both lines.
• 2 = 1:1 – provides line redundancy with traffic on the active line only.
Log: log State: active Privilege: GROUP1
