6-76
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 6 Logical Node, Port, and Signaling Commands
dspnodalcongth
dspnodalcongth
Display Nodal Congestion Thresholds
Displays configuration of the nodal congestion thresholds.
Cards on Which This Command Runs
PXM45
Syntax
dspnodalcongth
Output Description
setuphi The number of connection setup messages per second, above which the set-up
messages have congested the node.
Range: 1–105 calls per second
Default: 100 calls per second
statenqlo The number of status enquiry messages per second, below which the status enquiry
congestion condition is dropped.
Range: 1–500 calls per second
Default: 100 calls per second
statenqhi The number of connection setup messages per second, above which the status
enquiries have congested the node.
Range: 1 –500 calls per second
Default: 200 calls per second
connpendlo The aggregate number of connections in the establishment phase, below which
establishment congestion is dropped.
Range: 1–1000 connections
Default: 400 connections
connpendhi The aggregate number of connections in establishment phase above which the
establishment congestion sets in
Range: 1–1000 connections
Default: 500 connections
incompjour The number of incomplete journaling cycles that must be exceeded to increase the
journaling speed.
Range: 1–10 cycles
Default: 5 cycles
