5-17
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 5 PNNI Commands
aesa_ping
Example
This example shows the aesa_ping command line that pings the ATM end station with the address
47.00918100000000d058ac23ac.00d058ac23ac.01. The ping is configured as follows:
• No call is set up.
• The QoS metric is UBR.
• No trace is enabled.
• No data is sent with the ping.
• The ping waits six seconds for a reply.
• The ping re-occurs every 60 seconds unless it finishes.
• The peak cell rate of the ping is five cells per second (cps).
• The sustained cell rate of the ping is five cps.
SanJose.7.PXM.a > aesa_ping 47.00918100000000d058ac23ac.00d058ac23ac.01 -setupcall no
-qos ubr -trace no -data disable -timeout 6 -interval 60 -pcr 5 -scr 5
Ping Got CLI message, index=0
PING:from PNNI—SOURCE ROUTE
DTL 1 :Number of (Node/port)elements 2
DTL 1:NODE 1::56:160:71:0:145::238:238:238:238:Port 1:262656
DTL 1:NODE 2::56:160:71:0:145::88:172:35:172:Port 2:0
Port List :no of ports = 1
Port ID 1:262656
SanJose.7.PXM.a >
