Filter
Top Products
3. Place the storage subsystem in the rack.
Note: If you have removed the CRUs from the DS4500, you should be able to
lift the unit into the cabinet with the help of one other person. If you have
not removed the CRUs before the installation, you should have at least
two other people available to help you lift the DS4500 into the rack.
a. Move the storage subsystem to the front of the rackmount cabinet.
b. With help from another person, place the back of the storage subsystem on
the support rails, and then slide the unit into the rack as shown in Figure 21.
4. Using the screws that you removed in step 2 on page 38, secure the sides in
the back of the DS4500 to the rack rails.
5. Continue with one of the following actions:
v If you did remove the DS4500 CRUs before installation (as described in
“Removing the CRUs” on page 31), continue with “Replacing the
components” on page 40.
v If you did not remove the DS4500 CRUs before installation, continue with
Chapter 3, “Cabling the storage subsystem,” on page 47.
Figure 20. Controller unit screw removal
Figure 21. DS4500 Storage Subsystem mounting
Chapter 2. Installing the storage subsystem 39