Filter
Top Products
Status
Re
set
â
Storage
subsystem
fan lever
GS000035
3. Unpack the new storage subsystem fan.
4. Install the new storage subsystem fan:
a. Slide the new storage subsystem fan all the way into the slot.
Attention: Be sure that the lever is pulled straight out (in a horizontal
position) as you slide the unit into the storage subsystem.
b. Press down on the lever and snap the lever into place.
5.
Check the Fan LED, located on the storage subsystem front bezel, as shown in
Figure 103 on page 153.
Figure 102. Removing and installing the storage subsystem fan
152 IBM TotalStorage DS4500 Fibre Channel Storage Subsystem: Installation, User’s, and Maintenance Guide