Filter
Top Products
Appendix B. Rack mounting template
This appendix provides duplicate copies of the rack mounting templates. If you want
to tear out the templates from this document for easier use, use these copies rather
than those provided in “Installing the support rails” on page 27.
Use the following templates (Figure 112 on page 172 and Figure 113 on page 173)
to identify the proper locations for inserting M6 screws when mounting the support
rails and DS4500 to a rack. The locations for the M6 screws are highlighted in the
templates.
The DS4500 is 4 U high. Align the template with the rack at a U boundary. U
boundaries are shown as horizontal dashed lines in the rack mounting templates.
Note: The mounting holes that are shown in the following templates are square.
The holes in your rack might be round or square.
© Copyright IBM Corp. 2006 171