Filter
Top Products
Note: Before you remove the bezel, place the DS4500 Storage Subsystem on a
flat surface to avoid damaging the hooks on the bezel. If you pull the cover
out too far, you can damage the plastic hooks at the top. Be sure the front of
the DS4500 extends beyond the edge approximately 5 cm (2 in.).
1. Carefully pull out the bottom of the bezel on the front of the chassis to release
the pins.
2. Slide the bezel down, as shown in Figure 13.
Removing a storage subsystem fan
Complete the following steps to remove a storage subsystem fan:
1. Lift the storage subsystem fan lever to its open position (so that the lever is
horizontal and 90°); then, grasp the fan handle and pull out firmly to remove the
fan and save it for later reinstallation.
2. Slowly pull the lever away from the chassis to remove the storage subsystem
fan from the bay, as shown in Figure 14 on page 34.
3. Place the storage subsystem fan on a level surface.
Figure 13. DS4500 Storage Subsystem bezel removal
Chapter 2. Installing the storage subsystem 33