78
Assistance Section
Handling Cautions
• Before connecting other components to this player, be sure to turn them all off.
• Do not move the player while a disc is being played, or the disc may be scratched or broken, and the player’s
internal parts may be damaged.
• Do not put a flower vase filled with water or any small metal objects on the player.
• Be careful not to put your hand into the disc tray.
• Do not place anything other than the disc in the disc tray.
• Exterior influences such as lightning and static electricity can affect normal operation of this player. If this occurs,
turn the player off and on again with the POWER button, or disconnect and then reconnect the AC power cord to
the AC power outlet. The player will operate normally.
• Be sure to remove the disc and turn off the player after use.
Maintenance of Cabinet
For safety reasons, be sure to disconnect the AC power cord from the AC outlet.
• Do not use benzene, thinner, or other solvents for cleaning.
• Wipe the cabinet with a soft cloth.
Formation of Condensation
Due to sharp changes in temperature and humidity, condensation may form if warm air comes in contact with any cold
parts inside the player.
• When condensation forms inside the player, the player may not operate correctly. If this occurs, leave the player at
room temperature until the inside of the player becomes dry and operational.
• If condensation forms on a disc, wipe the disc with a soft and dry cloth by moving the cloth from the center hole
toward the outer edge.
Handling Discs
• Do not touch their signal surfaces. Hold by the edges or by one edge and the hole in the center.
• Do not affix labels or adhesive tape to label surfaces. Also, do not scratch or damage the label.
• Discs rotate at high speeds inside the player. Do Not use damaged (cracked or warped) discs.
Cleaning Discs
• Dirty discs can cause reduced video and audio performance. Always keep discs clean by wiping them gently with a
soft cloth from the inner edge toward the outer perimeter.
• If a disc becomes very dirty, wet a soft cloth in water, wring it out well. Wipe the dirt away gently, and them
remove any water drops with a dry cloth.
• Do not use record cleaning sprays or anti-static agents on discs. Also, never clean the discs with benzene, thinner,
or other volatile solvents which may cause damage to the disc surface.