Filter
Top Products
Chapter 8. PROGRAM SETUP
8-11
PV start setting value
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
P.S T A
■ Setting up PV start items
(1) In the setting display state, move to the PV start items on the programming map.
(The settings are common to all segments as the PV start items are setting items
provided for each program.)
(2) If you press
ENT
, the lower display starts blinking to indicate start of entry to the
No.1 setup.
(3) Press , , or to set to the No.1 setup PV start setting.
Setting range: 0 to 1
0:PV start disabled
1:PV start enabled
(4) When you press
ENT
, blinking on the lower display stops.
● Display
• The settings are common to all segments as the PV start items are setting items pro-
vided for each program.
• When setup data C 7 1 is set to 1, PV start items on the programming map are skipped
and not displayed.
■ Setting up cycle items
(1) In the setting display state, move to the cycle items on the programming map.
(The settings are common to all segments as the cycle items are setting items pro-
vided for each program.)
(2) If you press
ENT
, the lower display starts blinking to indicate start of entry to the
No.1 setup.
(3) Press , , or to set to the No.1 setup cycle setting.
Setting range: 0 to 9999
(4) When you press
ENT
, blinking on the lower display stops.
● Display
• The settings are common to all segments as the cycle items are setting items provided
for each program.
• When setup data C 7 1 is set to 1, cycle items on the programming map are skipped and
not displayed.
Cycle count setting value
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
C Y C L