Filter
Top Products
Chapter 7. PARAMETER SETUP
7-28
No. Item Code Item Factory User Setting
Setting Setting
11 C 1 1 0
12 C 1 2 0
13 C 1 3 0
14 C 1 4 0
15 C 1 5 0
16 C 1 6 0
17
C 1 7
0
18
C 1 8
0
19 C 1 q 0U
20 C 2 0 1000U
21 C 2 1 –
22 C 2 2 –
23 C 2 3 –
24 C 2 4 –
25 C 2 5 –
26 C 2 6 –
27 C 2 7 –
28 C 2 8 –
29 C 2 q –
30 C 3 0 –
PID set auto-
switching (CH1)
MV setting at input 1
over-range (MV1)
MV at input 1 over-
range (MV1)
Manual change
mode (MV1)
Preset manual value
(MV1)
MV in READY mode
(MV1, MV1 heat-
cool output)
MV (cool) in READY
mode (MV1 heat-
cool output)
Main output type
(CH1)
SP1 main output
lower limit (4mA
setting)
SP1 main output
upper limit (20mA
setting)
Unused
Unused
Unused
Unused
Unused
Unused
Unused
Unused
Unused
Unused
0: OFF (PID set segment designation)
1: ON
[Note]
When set to 1, the PID set items in the program are
invalid.
The switching point for auto-switching is set in variable
parameters (C P . 1 1 to C P . 1 7).
0: OFF
1: ON
-10 to 110%
[Note]
When C 1 2 setting is 0, “– – – –” is displayed and
setting is not possible.
0: Bump-less
1: Preset
[Note]
When the programmer function is selected, operation
is bump-less regardless of the setting of C 1 4.
-10 to 110%
[Note]
When C 1 4 setting is 0, “– – – –” is displayed and
setting is not possible.
-10 to 110%
[Note]
This setting is invalid even if the programmer function
is selected by C 1 8 setting.
On heat/cool models, this setting functions as the MV
(heat) setting in the READY mode.
-10 to 110%
[Note]
When the model is not a heat/cool model, “– – – –” is
displayed and setting is not possible.
0: MV1 output (controller function)
1: SP1 output (programmer function)
[Note]
When the model is not a 5G output model, “– – – –” is
displayed and setting is not possible.
-1999 to 9999U
[Note]
When the model is not a 5G output model and 8
setting is 0 on a 5G output model, “– – – –” is dis-
played and setting is not possible.
The relationship between the analog outputs and SP1
can be inverted by inverting the upper and lower limit
values.
[Note]
“– – – –” is displayed and setting is not possible.