Filter
Top Products
78
RQT8346
Changing the unit’s settings
When connecting with an HDMI cable to an amplifier, use the
following settings on this unit if you cannot set the speaker delay
effect on the amplifier.
[1] Press [3, 4, 2, 1] to select the speaker icon (A) and then
press [ENTER].
[2] Press [3, 4] to select the setting and then press [ENTER].
Icon examples:
Surround speaker (LS)
≥Large: Select when the speaker supports low-frequency (under
100 Hz) reproduction.
≥Small: Select when the speaker does not support low-frequency
reproduction.
If the subwoofer is set to “No”, the front speakers will automatically
be set to “Large”. (In this case, we recommend connecting a
speaker that can reproduce bass below 100 Hz.)
(Effective when playing multi-channel audio)
If either distance C or E is less than D, find the difference in the
relevant table and change to the recommended setting.
[1] Press [3, 4, 2, 1] to select the speaker icon (B) and then
press [ENTER].
[2] Press [3, 4] to select the setting and then press [ENTER].
∫ Changing the speaker setting to suit your
speaker
Speaker presence and size (A)
Delay time (B)
C Center speaker
Difference Setting
Approx. 34 cm (1
1
/
10
feet)
1.0 ms
Approx. 68 cm (2
1
/
5
feet)
2.0 ms
Approx. 102 cm (3
3
/
10
feet)
3.0 ms
Approx. 136 cm (4
2
/
5
feet)
4.0 ms
Approx. 170 cm (5
1
/
2
feet)
5.0 ms
E Surround speakers
Difference Setting
Approx. 170 cm (5
1
/
2
feet)
5.0 ms
Approx. 340 cm (11 feet) 10.0 ms
Approx. 510 cm (16
1
/
2
feet)
15.0 ms
ms
ms
L
Complete
LS
R
SW
C
RS
0.0
0.0
A B A
A
A
AB
A
Center
Front (L)
Front (R)
Subwoofer
(RS)(LS)
Complete
Surround
LS
LS
Large Small No
LS
RS
L
R
SW
E
D
C
C
M6740P.book 78 ページ ２００６年１月３０日 月曜日 午後３時３０分