Filter
Top Products
Appendix
Appendix A-15
Note
In the PROGRAM SET, PAUSE, PLAY or
PROGRAM CLEAR mode, the program area is
00 if there is no DATA2.
RETURN command: 0ACH
MULTI ACCESS SET
Command: 02DH
Function: Plays, memorizes, and clears the track data
specified for multi-access function.
DATA: 1
DATA1: (10, 1): Instant playback of slot No.1-
10
DATA1: (10, 1): 0AAH: Loading the track
data into the memory
DATA1: (10, 1): 0CCH: Clearing the setting
DATA1: (10, 1): 0FFH: Used for sense to
show the slot number currently played.
RETURN command: ADH
Notes
• Merely presetting using the command 25H
will not set the track data into memory. The
DATA1: 0AAH of this command should be
executed to set the track data into memory
before instant playback.
• Clearing the track data in the memory using
0CCH must be done while the MD deck is
stopped.
• The sensing must be done during playback or
pause status.
AUTO PAUSE, AUTO CUE
SELECT
Command: 030H
Function:
• AUTO PAUSE function:
The PAUSE status is set at the beginning of next
track automatically when certain track is
finishes playing. This function is used when
you do not want continuous play or when you
want to locate a specific track but not to play it
immediately. Also, this function is active in
repeat play or program play operation.
Further, the use of TRACK No. LOCATE
command causes the PAUSE status to be set
when the specified track is located.
• AUTO CUE function:
When locating a track, if there is a silent part at
the beginning of track, this function skips that
part up to the sound rising part and pauses the
deck. This function is used in the PAUSE status
at the beginning of a track to adjust finely the
transmission of PLAY command with the sound
rising timing.
DATA: 1
DATA1
000H: AUTO PAUSE OFF
001H: AUTO PAUSE ON
002H: AUTO CUE ON
0FFH: sense
RETURN command: 0B0H
AUTO DISPLAY SELECT
Command: 031H
Function : Switches the display on the deck between
title display and the time display. Since the title
and time are displayed simultaneously at all
times, the deck does not respond to this
command.
DATA: 1
DATA1
0FFH: (always returns 001H = AUTO
DISPLAY ON)
RETURN command: 0B1H
END OF MESSAGE TIME
PRESET
Command: 032H
Function : This function outputs the status from RS-
232C connector when the remaining time up to
the end of track becomes several seconds
(settable range: 1 to 35 sec. in the Track EOM
and 1 to 10 sec. in the Disc EOM) during
playing of a certain track.
The use of this function enables control of other
external equipment, expecting the end of track.
Note
To turn off this function, set the EOM to 000H.
DATA: 1
DATA1