Filter
Top Products
Chapter 7 Setup Menu
Chapter 7 Setup Menu 7-9
7-9 Reading the Hours Meter
This function allows you to display the accumulated
operating time of the laser diode (during recording
operations) and of the spindle motor. Use this
information as the basis for replacing the BU block.
To display the digital hours meter
1 Press the EDIT/NO button while holding down the
STOP button.
The Setup menu appears.
2 Turn the AMS control until the menu item F25.
S: Accumulated spindle motor operating time
L: Accumulated laser diode operating time
3 After checking the meter, press the EDIT/NO
button to exit the Setup menu.
Note
When the BU block is replaced, a new EEP-ROM is
installed and the hours meter is zeroed. Since this
resets the other menu functions as well, you must
make the applicable settings again.
1
3
2
p(P
0)
=+
r
S0001 L0000
F25