Filter
Top Products
Appendix
Appendix A-13
000H: If there are no DATA2 and DATA3: A
track currently being played or paused and the
previous track are combined.
If there are DATA2 and DATA3: When in the
STOP mode, a track specified by the DATA2
and DATA 3 and the previous track are
combined.
001H: Starts rehearsal play for combining the
tracks at the position where the two tracks will
be joined. If there are DATA2 and DATA3,
the rehearsal playback at the position where
the track specified by DATA2 and DATA3
and the previous track will be joined starts.
002H: The tracks are combined at the rehearsed
position
DATA2 (10, 1)
DATA3 (**, 100)
Specify the track No. to be combined in the
STOP mode.
Note
Sending this command in the PLAY mode could
change the track numbers and may result in
confusion. Therefore, operation should be
performed in the PAUSE status.
RETURN command: None
MOVE
Command: 019H
Function : Moves a specific track to the desired
position to change the order of play.
Issue this command in the STOP, PLAY or
PAUSE mode.
DATA: 2 (4)
DATA1 (10, 1)
DATA2 (**, 100) destination (001-255, decimal
number)
DATA3 (10, 1)
DATA4 (**, 100) the track to be moved (001-
255, decimal number)
Notes
• If the MOVE command is executed in the
PLAY or PAUSE mode, DATA: 2 is
required.
Sending this command in the PLAY mode
could change the track numbers and may
result in confusion.
• If the MOVE command is executed in the
STOP mode, DATA: 4 is required.
• This command is not accepted in the
RECORD mode.
RETURN command: None
TRACK LOCATE
Command: 01AH
Function : Skips the tracks in forward or reverse
direction.
DATA: 1
DATA1
000H: NEXT
001H: PREVIOUS
RETURN command: None
TRACK No. LOCATE
Command: 01BH
Function : Locates a specific track. This command is
used together with the “TRACK No. LOCATE
POINT PRESET” (023H) command described
below to locate a track preset by the 023H
command.
Note
Although the deck does not provide this
function, the devices used for recording or
playback supports this function by operating the
10 keys on the remote controller.
DATA: None
RETURN command: None
TRACK No. LOCATE POINT
PRESET
Command: 023H
Function : Specifies the track to be located.
This command is used together with the “TRACK No.
LOCATE” (01BH) command listed above.
DATA: 2 (1)
DATA1 (10, 1) (*001 to 255, decimal number)
DATA2 (**, 100)
DATA1=0FFH: TRACK No. LOCATE POINT
SENSE
However, when DATA1 is 0FFH, TRACK No.
LOCATE POINT SENSE becomes active to
request the RETURN command 0A3H.
RETURN command: 0A3H
PGM TRACK No. PRESET
Command: 024H
Function : Selects the tracks for program play.