Filter
Top Products
Performing Diagnostics
Viewing Adapter Port Transceiver Details
SN0054651-00 F 6-9
A
Serial Number. Indicates the vendor serial number for the transceiver
device.
Type. Describes the transceiver device based on information that SANsurfer
FC HBA Manager reads from the device.
For instance, the type 400-M6-SN-I describes a transceiver device that has
a speed of 400 MBps (400), uses a multimode 62.5 m (M6) laser, which is a
shortwave laser without OCF (SN) for an intermediate distance (I).
Speed. Indicates the data transfer rate for the transceiver device in
Mbytes/sec.
Diagnostic Data
The Diagnostic Data section shows the existing Value, Status, High Alarm
value, High Warning value, Low Warning value, and Low Alarm value for the
following data:
Temperature (C). Temperature of the transceiver device in degrees
centigrade
Voltage (V). Voltage of the transceiver device power supply in volts
Tx Bias (mA). Transmitting laser bias current in mA
Tx Power (mW). Coupled transmitter output power of the laser in mW
Rx Power (mW). Received optical power in mW
The Value shows the existing number value for the datum. The Status shows its
rank as Normal, Warning, or Fault. Normal status appears in a cell in the
Diagnostic Data section. Fault status appears in a cell, and warning status
appears in a cell. A fault status requires immediate action.
Each datum has a High Alarm and a Low Alarm value. If a datum exceeds the
High Alarm value or falls below the Low Alarm value, the conditions are likely to
cause an inoperable link and require immediate action.
Additionally, each datum has a High Warning value and Low Warning value.
Warnings indicate conditions outside the normally guaranteed bounds, but are not
necessarily causes for immediate link failures.
NOTE:
Specific warning flags may represent the manufacture's end of life
indicators.
green
red
yellow