Filter
Top Products
Chapter 5 Installing Optional Products
5.1 Installing Disks
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
56
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
5.1.1 Installation Rules for Disks
This section explains the installation rules for disks.
■ 2.5" disks
2.5" disks can be installed in the front side of a 2.5" type controller enclosure.
Disks can be installed in any slots of an enclosure.
Figure 5.1
shows the positions of 2.5" disk slots.
Figure 5.1 Position of 2.5" disk slots
■ 3.5" disks
3.5" disks can be installed in the front side of a 3.5" type controller enclosure or a 3.5" type drive
enclosure.
Different types of disks can be installed in the same enclosure. Disks can be installed in any slots
of an enclosure.
Figure 5.2
shows the positions of 3.5" disk slots.
IMPORTANT
Firmware version V20L11 or later is required in the ETERNUS DX Disk
storage system to add disks.
The firmware version that is currently in use can be checked via ETERNUS
Web GUI or ETERNUS CLI. If an older firmware version is being used,
request a firmware upgrade from your sales representative.
WARNING
Do Not
• System disks are installed in Slot#0 and Slot#1. Never remove system
disks. Doing so will render the ETERNUS DX Disk storage system
unusable.
Slot#8
Slot#9
Slot#10
Slot#11
Slot#12
Slot#13
Slot#14
Slot#15
Slot#0
Slot#1
Slot#2
Slot#3
Slot#4
Slot#5
Slot#6
Slot#7
Slot#16
Slot#17
Slot#18
Slot#19
Slot#20
Slot#21
Slot#22
Slot#23