Fujitsu DX60 Portable Media Storage User Manual


 
Chapter 4 Operations
4.2 Monitoring ETERNUS DX Disk Storage System Status
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
53
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
Table 4.1 General status of ETERNUS Web GUI
Refer to "ETERNUS Web GUI User's Guide" for details.
4.2.3 Event Notification
By setting event notification, if an error (event) occurs in the ETERNUS DX Disk storage system,
the event information is notified.
The methods that can be used to notify an event are "E-Mail", "SNMP Trap", "REMCS", and
"Host Sense Key Code Qualifier". Note that REMCS is not available in the EMEA&I region.
For the procedure on setting event notification, refer to "User's Guide -Installation-".
E-Mail
When an event occurs in the ETERNUS DX Disk storage system, an e-mail is sent to the speci-
fied e-mail address.
For more details on notified event information, refer to "Appendix A Event Notification Message
List" (page 87).
SNMP Trap
When an event occurs in the ETERNUS DX Disk storage system, an SNMP Trap is sent to the
SNMP Manager (monitoring server).
For more details on event information notified by SNMP Trap, refer to "Appendix A Event
Notification Message List" (page 87).
REMCS
The information for errors that occur in the ETERNUS DX Disk storage system is notified to the
remote support center.
Warning and Error events are notified.
Host Sense Key Code Qualifier
When an event occurs in the ETERNUS DX Disk storage system, host senses (sense codes) are
sent to the server. For details on sense codes, refer to "Appendix A Event Notification Message
List" (page 87).
General status ETERNUS DX Disk storage system status
Normal (Green)
The ETERNUS DX Disk storage system is in normal state.
Not Ready (Red)
"Not Ready" is a status where an abnormality is detected at a
power-off, and I/O access from the server cannot be received.
Error (Red)
The ETERNUS DX Disk storage system is in error state.
Maintenance (Orange)
The ETERNUS DX Disk storage system is under maintenance.
Warning (Yellow)
The ETERNUS DX Disk storage system is in warning state.
Warning (Gray)
The component is installed in the ETERNUS DX Disk storage
system, but not used.