Fujitsu DX60 Portable Media Storage User Manual


 
Chapter 1 Components
1.2 Drive Enclosures
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
24
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
Dual expander type
Figure 1.19 Rear view of drive enclosure (dual expander model)
1.2.3 Components (Front)
This section describes the operation panel and the disks in the front of the drive enclosure.
Operation panel
An operation panel has LEDs, an AUTO POWER switch, a MODE SELECT switch, and an IP
RESET switch.
Figure 1.20 LEDs on the front side of the drive enclosure
Part explanation
AUTO POWER switch
The AUTO POWER switch of the drive enclosure is turned to "OFF" as the factory setting,
and should not be turned to "ON".
MODE SELECT switch
Enables the device power to be turned on via power linkage.
The MODE SELECT switch is enabled for the factory default setting. Do not change to OFF.
LEDs
The states of LEDs are listed below.
Power Supply Unit
(PSU#0)
Power Supply Unit
(PSU#1)
Expander (EXP#0) Expander (EXP#1)
POWER LED
READY LED
IDENTIFY LED
FAULT LED
AUTO POWER switch
MODE SELECT switch
This switch is not used.
With a front cover Without a front cover